0 $0.00



How To Anodize Titanium

In this article will go over how to anodize your own titanium parts start to finish.

DIY Titanium Acid Etch

Is Etching Worth Your Time? Etching your titanium before anodizing will better prepare the surface of your titanium for anodizing. Using an etch will increase the potential vibrancy and the

Small Metal Bender

Overview Needed some steel bar bent. Rather then heating it up and bending, I came up with this super simple machined designed. Used Fusion 360’s new ‘Flat’ toolpath to get

8×8 Vacuum chuck

Table of Contents Overview Needed a custom sized vacuum chuck, so I made this. Diameter of external hole is for 1/4 npt tap Based on using Pierson Workholding’s gasket. I

Turning your mill into a lathe

Overview I needed lathe quality round parts, and at the time I only had the vertical mill. It’s actually not to difficult to get this to work smoothly. Programmed in

    Your Cart
    Your cart is emptyReturn to Shop
      Calculate Shipping
      Apply Coupon

      Designed, and Developed in USA

      Copyright © 2024 | Triiaxis

      All Rights Reserved