0 $0.00

Triiaxis

Table of Contents

8×8 Vacuum chuck

8×8 Vacuum chuck

Table of Contents

Overview

Needed a custom sized vacuum chuck, so I made this.

  • Diameter of external hole is for 1/4 npt tap
  • Based on using Pierson Workholding’s gasket. I think it’s .125, can be purchased off the shelf.
  • Slots are .118″ wide, .095″ deep.
  • Designed to fit on an orange 8×8 ZPS pallet
  • Holes on top of chuck are for 1/4-20s for a top plate
  • Vacuum hole is a tapped 10-24 (Can just be a through hole, tapped to be plugged if needed)
  • One .25″ locating hole.

Build list

  1. This cad file: Download Link
  2. I used an Orangevise 8×8 pallet. Otherwise any sizable chunk of aluminum should do.

Leave a Comment

Your email address will not be published. Required fields are marked *

Recent

How To Anodize Titanium

In this article will go over how to anodize your own titanium parts start to finish.

DIY Titanium Acid Etch

Is Etching Worth Your Time? Etching your titanium before anodizing will better prepare the surface of your titanium for anodizing. Using an etch will increase the potential vibrancy and the

    0
    Your Cart
    Your cart is emptyReturn to Shop
      Calculate Shipping
      Apply Coupon

      Designed, and Developed in USA

      Copyright © 2024 | Triiaxis

      All Rights Reserved